Chapter 3: Commissioning & setup 39
5. The screen will show the
CLEAR TO MANEUVER
message. Ensure it is safe to
continue, then press
auto
to start the AutoLearn maneuvers:
• The boat will start a series of zig-zag turns and the display will show
LEARNING
with a number to indicate the current AutoLearn stage. This number increases
as AutoLearn progresses.
• A typical AutoLearn completes within 7 to 27 steps (depending on boat
characteristics and sea conditions).
Note:
To cancel an AutoLearn, press standby or disp.
6. When the SPX-5 Tiller system has finished learning, the controller will beep and
display either
LRN PASS
or
LRN FAIL
:
•
LRN PASS
= AutoLearn completed successfully.
•
LRN FAIL
= AutoLearn was not successful, so should be repeated. One of the
following failure codes will also be displayed:
1
= AutoLearn has not been carried out.
2
= AutoLearn failed, due to manual interruption.
4
= AutoLearn failed, probably due to drive or compass failure.
5
= AutoLearn failed, probably due to motor current limiting.
6
= AutoLearn failed, probably due to boat spinning.
7. If the AutoLearn was successful, hold down standby for 2 seconds to store the
new settings.
2 sec
x2
• steer straight ahead at cruising speed
(planing boats – just on the plane)
• head into wind and waves
x4
D10545-1
AutoLearn in progress
Prepare for AutoLearn
Start
AutoLearn
Enter Seatrial calibration
CHECK!
Before proceeding, ensure
you have sufficient clear
sea space
To Next Page
Loading...
