Record 6100 Series User Manual

AKKU PASS
FLASH PASS
EEPROM PASS
RTC PASS
CAN PASS
FPC902
Version 3.20
Feb 16 2018
14:32: 06
Service STG >
FPC902
Service STG Slave >
Service sensor >
Flash-Programmer >
Setup >
Connect with STG ...
Yes
Accept all parameter
from the STG?
Offline
Parameter download
from STG ...
Continue
DFA127 V2.60
USA Low Energy
Manual
52 No running parameters
SERVICE STG
Configure System >
Learning System >
Parameter >
Maintenance >
Functions >
Press “OK”
Press “OK”
Press “OK”
After the operator has been mechanically installed, the arms attached to the
door, and 120VAC connected to the power supply, connect the FPC902 Hand
Terminal to the operator control. The following sequence of screens will occur.
The final screen shown below is the base point from which various settings for
the operator are accessed and modified.
The screen sequences on the following pages start from this point and document the various
adjustable parameters in the control. When at any of the screens shown below, the above
screen can be accessed by pressing the “ESC” key one or more times.
Aug2018
Servicing the Series 6100 & 8000 with the FPC-902 Hand Terminal
1
SERVICE STG
Configure System >
Learning System >
Parameter >
Maintenance >
Functions >
Operation Mode >
BG

Record 6100 Series Specifications

General

Power Supply	24V DC
Series	6100 Series
Type	Programmable Logic Controller
Programming Language	Ladder Logic, Function Block Diagram
Communication Ports	RS-232, RS-485
Operating Temperature	0°C

Summary

Service STG Configuration

Configure System Parameters

Set up Door Type, Lock Type, and other basic system settings.

Driving Cycle Settings

Adjust closing speed, opening speed, acceleration, and delays.

Obstruction and Brake Control

Configure obstruction detection sensitivity and electric brake operation.

Arm Type and Operation Modes

Select arm type, Invers, Spring Type, and Momentum operation modes.

Entrance and Manual Control

Configure entrance system parameters and manual operation modes.

Control Panel and Locking

Configure display, keyboard, brightness, and locking functions.

Input/Output and Communication

Configure external sensors, outputs, and communication protocols.

System Maintenance and Functions

Maintenance Schedule Setup

Configure maintenance notifications and target values.

System Functions and Calibration

Perform factory resets, calibration, and learning cycles.

Diagnostics and Software Management

Diagnostics and Status Monitoring

View operation modes, input status, and error history.

Software Update and Licensing

Update door software and manage licenses.

Advanced Operation and Troubleshooting

Synchronized Operator Setup

Configure settings for dual-operator synchronized doors.

Alarm Codes and Error Messages

Comprehensive guide to error codes and troubleshooting.