Record 6100 Series - Arm Type and Operation Modes

SERVICE STG
Parameter >
Maintenance >
Functions >
Operation mode >
Diagnostics >
PARAMETER
Driving cycle >
Time delay open >
Drive >
Entrance system >
Manual control >
Control panel >
SERVICE STG
Parameter >
Maintenance >
Functions >
Operation mode >
Diagnostics >
PARAMETER
Driving cycle >
Time delay open >
Drive >
Entrance system >
Manual control >
Control panel >
DRIVE
Obstruction close 20
Brake 0
Types of arms 0
Inverse 0
Momentum 0
Not used in North America configurations.
6
SERVICE STG
Parameter >
Maintenance >
Functions >
Operation mode >
Diagnostics >
PARAMETER
Driving cycle >
Time delay open >
Drive >
Entrance system >
Manual control >
Control panel >
SERVICE STG
Parameter >
Maintenance >
Functions >
Operation mode >
Diagnostics >
PARAMETER
Driving cycle >
Time delay open >
Drive >
Entrance system >
Manual control >
Control panel >
INVERS operation is when the operator
is to be installed as a Power Close,
Spring Open configuration - typically
used in certain smoke evacuation
installations. The installation must
either have the optional internal electric
brake or an external electric lock to hold
the unit in the closed position.
Setting the Arm Type will adjust the
open and close check points based
upon the arm selected.
SERVICE STG
Parameter >
Maintenance >
Functions >
Operation mode >
Diagnostics >
PARAMETER
Driving cycle >
Time delay open >
Drive >
Entrance system >
Manual control >
Control panel >
Used for Overhead Concealed,
Direct Drive installations. During
first run and normal operation, the
operator will not push against the
close stop (which may not be
present on some inswing units).
Operati
Operati
Operati
Operati
Operati
DRIVE
Opening angle 40
Obstruction Close 20
Brake 0
Types of arms 0
Inverse 0
Obstruction Open 20
DRIVE
Opening angle 40
Obstruction Close 20
Brake 0
Types of arms 0
Inverse 0
Obstruction Open 20
DRIVE
Opening angle 40
Obstruction Close 20
Brake 0
Types of arms 0
Inverse 0
Obstruction Open 20
DRIVE
Opening angle 40
Obstruction Close 20
Brake 0
Types of arms 0
Inverse 0
Obstruction Open 20
DRIVE
Opening angle 40
Obstruction Close 20
Brake 0
Types of arms 0
Inverse 0
Obstruction Open 20
DRIVE
Opening angle 40
Obstruction Close 20
Brake 0
Types of arms 0
Inverse 0
Obstruction Open 20
TYPES OF ARMS
0 Standard arm
1 Sliding pulling
2 Sliding pushing
3 Inheader
INVERS
0 disabled
1 enabled
DRIVE
Opening angle 40
Obstruction Close 20
Brake 0
Types of arms 0
Inverse 0
Obstruction Open 20
DRIVE
Opening angle 40
Obstruction Close 20
Brake 0
Types of arms 0
Inverse 0
Obstruction Open 20
SPRING TYPE
0 Unknown
TYPES OF ARMS
0 Standard arm
1 Sliding pulling
2 Sliding pushing
3 Inheader
Obstruction close 20
MOMENTUM
0 disabled
1 enabled
When enabled, provides a burst mode
for initial power to open the door. The
pulse at initial opening would provide
sufficient power to overcome resistance
on a Total Door or cam-lift hinges as an
example when in USA Door Type.