Record 6100 Series - System Maintenance and Functions; Maintenance Schedule Setup

15
SERVICE STG
Parameter >
Maintenance >
Functions >
Operation mode >
Learning System >
MAINTENANCE
Reset maintenance >
Setup maintenance >
Cycles1000 ACTUAL 0
Cycles1000 TARGET 0
Weeks ACTUAL 0
Weeks TARGET 0
SETUP MAINTENANCE
Save in the STG >
Cycles1000 TARGET 0
Weeks TARGET 0
Phone 8004381937
WEEKS TARGET
0
SERVICE STG
Parameter >
Maintenance >
Functions >
Operation mode >
Learning System >
MAINTENANCE
Reset maintenance >
Setup maintenance >
Cycles1000 ACTUAL 0
Cycles1000 TARGET 0
Weeks ACTUAL 0
Weeks TARGET 0
SETUP MAINTENANCE
Save in the STG >
Cycles1000 TARGET 0
Weeks TARGET 0
Phone 8004381937
CYCLES1000 TARGET
0
Useful in setting up a maintenance
schedule.
Useful in setting up a maintenance
schedule.
SERVICE STG
Parameter >
Maintenance >
Functions >
Operation mode >
Learning System >
MAINTENANCE
Reset maintenance >
Setup maintenance >
Cycles1000 ACTUAL 0
Cycles1000 TARGET 0
Weeks ACTUAL 0
Weeks TARGET 0
SETUP MAINTENANCE
Save in the STG >
Cycles1000 TARGET 0
Weeks TARGET 0
Phone 8004381937
Save in the STG
Are you sure?
Yes
No
SERVICE STG
Parameter >
Maintenance >
Functions >
Operation mode >
Learning System >
MAINTENANCE
Reset maintenance >
Setup maintenance >
Cycles1000 ACTUAL 0
Cycles1000 TARGET 0
Weeks ACTUAL 0
Weeks TARGET 0
Reset maintenance
Are you sure?
Yes
No
Useful in setting up a maintenance
schedule.
Useful in setting up a maintenance
schedule.
Configu
Configu
Configu
Configu
Set to 0 if you do not want a
maintenance notification.
Set to 0 if you do not want a
maintenance notification.
SERVICE STG
Parameter >
Maintenance >
Functions >
Operation mode >
Learning System >
PARAMETER
Manual control >
Control panel >
Locking >
Input >
Output >
Miscellaneous >
MISCELLANEOUS
Push to actuate 0
Alarm display >
ALARM DISPLAY
Time activation 16
Time safety 16
Sets the length of time a continuous
safety signal (terminals 5, 8, 10 & 12)
will initiate an alarm status (red LED
blinking on control panel or message
on Display Control Panel). Adjusts in
5 second increments -
0 = Disables alarm
1 = 5 seconds before alarm
12 = 60 seconds before alarm
40 = 200 seconds before alarm
Configu