Reely Raptor 6S - Vehicle Fails to Stop; Steering System Issues; Throttle Response Reversal

68
The vehicle doesn’t stop when the throttle/brake lever is released
• Correct the throttle trim on the remote control (set the neutral position).
• Ifthetrimisinsufcient,resettheneutralandfullthrottlepositions(seesection10a).
The vehicle does not travel in a straight line
• Set the steering trim on the remote control.
• Check the steering linkage, the servo arm and the screw connection.
• Has the vehicle had an accident? If so, check the vehicle for any defective or broken parts and replace them if
necessary.
The vehicle moves in the opposite direction to the steering wheel on the remote control
• Enable the steering reverse function on the remote control.
The vehicle responds in the opposite way to the throttle/brake lever on the remote control
• Usually, the vehicle should move forwards when the throttle/brake lever on the remote control is pulled towards
the handle.
If this is not the case, enable the reverse throttle on the remote control.
• If the motor was disconnected from the speed controller, swap the positions of two of the three motor cables.
The vehicle does not steer properly or the steering angle is too low
• If the transmitter has a dual rate setting, check that it is working correctly (refer to the remote control operating
instructions for details). If the dual rate setting is too low, the steering servo will not respond.
• Check the steering mechanism for loose parts (e.g. check whether the servo arm is attached correctly to the servo).