EasyManua.ls Logo

Regency P36E-NG10 - Conversion from NG to LP

Regency P36E-NG10
72 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
P36E-10 Zero Clearance Direct Vent Gas Fireplace | 37
37
|
installation
CONVERSION FROM NG TO LP
P36E-10 USING SIT 885 GAS VALVE
Each Kit contains one LP
Conversion Kit
LP Conversion Kit Contains:
Qty. Part # Description
1 904-390 BurnerOrice#52
1 918-590 Decal“Convertedto
LPG”
1 908-528 Red“LPG”label
1 904-529 5/32”AllenKey
1 911-011 Hi/Loregulator
1 910-101 LPGInjector(PilotOrice)
1 919-473 InstructionSheet
ConversionfromNGtoLPG
forP36EusingSIT885NOVAGasValve
THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER
IF IN DOUBT DO NOT DO THIS CONVERSION !!
Installation of the LP
Conversion Kit:
1) Shutoffthegasandelectricalsupply.
2)
a)Removethesafetyscreenandface-
plate,ifinstalled.
b) Openandremovetheglassdoor.
c) Removethelogs,embers,andbrick
panels(ifused).
8) ReinstallnewburneroriceLPstamped
#52andtighten
6) Unscrewthepilotoricewiththeallen
key;thenreplacewiththeLPpilotorice
andthepilotcap,providedinthekit.
7) Removeburneroricewitha1/2"
wrench.Useanotherwrenchtoholdon
totheelbowbehindtheorice.Discard
orice.
Burner Orice
Remove the 2 screws, push Burner Assembly
to the left and lift out.
3) Removethe2screwsholdingtheBurner
Assemblytothereboxbase.Pushthe
BurnerAssemblytotheleftandliftout.
Installer Notice:
These instructions must be left
with the appliance.
4) Removethewireclipbelowthepilotcap.
Pilot retainer clip
5) Pulloffthepilotcaptoexposethepilot
orice.
9) Disconnectthecablefromthepressure
regulatormotor.
Motor wire
10) RemoveHi/Lopressureregulatorby
removing2screwsasshownbelow.
ReversestepstoinstallLPpressure
regulator.Reattachpressureregulator
wire.
11) Attachthelabel“Thisunithasbeen
convertedtoLPG”nearorontopofthe
serial#decal.
12) Replaceyellow“NG”labelwithred
“LPG”label.
13) Reversesteps3-1.
14) Checkforgasleaks.
15) Checkinletandoutletpressures.
16)Checkoperationofamecontrol.
919-473
10.28.14
1
P36E

Table of Contents

Related product manuals