Regency P36E-NG10 - Optional Wall Thermostat; AC Power Adaptor Installation (for Surefire Systems)

48 | P36E-10 Zero Clearance Direct Vent Gas Fireplace
|
48
installation
AC POWER ADAPTOR INSTALLATION (FOR SUREFIRE SYSTEMS)
An AC power adaptor is supplied with this appliance and may be installed as a constant power source for the SureFire system.
NOTE: AC power adaptor is not required when using GTMF Remote with fan control module and must be disconnected.
IMPORTANT: Recommend removing the 4-AA batteries in the SureFire receiver.
This will avoid battery leakage and power drainage. 4-AA Battery pack may be re-installed into receiver during power outages.
919-063
10/09/14
1. Plug AC adaptor into a 120V wall outlet or into the 120V
receptacle if installed inside the gas replace.
2. Tuck any loose wires neatly underneath the rebox–inside
the replace.
Note: Ensure that wires do not touch the underside of the re
box (Keep wires away from heat as much as possible).
AC adaptor
Wire adaptor
1
AC POWER ADAPTOR INSTALLATION (FOR SUREFIRE SYSTEMS)