EasyManua.ls Logo

Reliance 7900 - Chair Assembly

Reliance 7900
60 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
IN-790012
FIGURE 4B
FIGURE 4C
FIGURE 4D
Reference to changing the Instrument Stand
from a right-handed to a left-hand unit.
2.10. Chair Assembly
2.10.1 The chair control switches located on the Floor Unit
may control any Reliance® low voltage chair. Refer to the
chair’s Installation and Operatiing Instructions for unpacking
and assembling the chair.
2.10.2. A Chair Control Cable is provided to control the
vertical movement of the Chair Base from the Floor Unit.
One end of the cable is to be inserted into the black circular
receptacle on the Outlet Plate Assembly. See Figure 4. The
other end of the cable is to be inserted into the mating
receptacle marked “CHAIR CONTROL CABLE” in the rear
of your Reliance® chair.
CAUTION-“Accessory equipment connected
to analog and digital interfaces must be
certified according to the respective IEC
standards (i.e. IEC 60950 for data processing
equipment and IEC 60601-1 for medical
equipment). Furthermore, all configurations
shall comply with IEC 60601-1-1 for medical
equipment systems. Anyone who connects
additional equipment to the Signal Input
Part (SIP) or Signal Output Part (SOP)
configures a medical system, and is therefore
responsible that the system complies with the
requirements of IEC 60601-1-1. If in doubt,
consult the Technical Service Department, or
your local “Reliance”® Distributor.”
PRÉCAUTION : L’équipement accessoire
connecté aux interfaces analogues et
digitales doit être certifié selon les normes
IEC respectives (c.-à-d., IEC 60950 pour
l’équipement de traitement de données et
IEC 60601-1 pour l’équipement médical).
De plus, toutes les configurations doivent
être conformes à IEC 60601-1-1 pour les
systèmes électriques médicaux. Quiconque
connecte de l’équipement supplémentaire
à la partie entrée de signal ou à la partie
sortie de signal configure un système
médical et est par conséquent responsable
de la conformité du système avec les
exigences de IEC 60601-1-1. En cas de
doute, consultez le service technique ou
votre distributeur Reliance® local.

Table of Contents

Related product manuals