IN-7900
27
TROUBLE SHOOTING GUIDE
INSTRUMENT STAND
Should your Instrument Stand not perform properly, contact the Reliance®
Distributor, where you purchased this product or contact the Technical
Service Department, Reliance® Medical Products, Inc., 3535 Kings Mills
Road, Mason, Ohio 45040-2303, or call (800) 735-0358.
PROBLEM
PROBLEM CAUSE SOLUTION
1) UNIT NOT GETTING POWER A) UNIT NOT PLUGGED INTO OUTLET A) PLUG POWER CORD INTO WALL
B) BLOWN FUSE(S) B) REPLACE FUSE (S)
C) BASE CAP OR CONSOLE NOT
PLUGGED IN
C) PLUG BASE CAP OR CONSOLE
INTO BASE
2) CHAIR CONTROLS NOT
FUNCTIONING
A) CHAIR CONTROL CABLE NOT
CONNECTED TO STAND
A) CONNECT CHAIR CONTROL
CABLE TO STAND
B) BASE CAP OR CONSOLE NOT
CONNECTED TO CONTROL CABLE
B) CONNECT BASE CAP OR
CONSOLE TO CONTROL CABLE
ON TOP OF THE STAND
3) WELLS NOT RECHARGING A) UNIT NOT PLUGGED INTO OUTLET A) PLUG POWER CORD INTO WALL
B) POOR CABLE CONNECTION B) CONNECT CABLE TO WELL PCB
4) OVERHEAD LAMP NOT
FUNCTIONING
A) OVERHEAD LAMP NOT PLUGGED
INTO "LAMP" OUTLET
A) PLUG OVERHEAD LAMP INTO
"LAMP" OUTLET
5) AUXILIARY ARM NOT
RECEIVING POWER
A) AUXILIARY ARM NOT PLUGGED
INTO BASE CAP OR CONSOLE
A) PLUG AUXILIARY ARM INTO
BASE CAP OR CONSOLE
To Next Page
Loading...
