5 MAN-GD-2300-002
Warning – Transport Safety
Before transporting or traveling on public roads with this grain drill, make certain that every operator:
• Reads and understands the manual pertaining to the drill.
• Checks and complies with state and local regulations.
• Makes sure SMV, reflectors and warning lights are in working order.
• Uses tractor warning lights during transporting.
• Uses required warning flags, emblems and lights.
• Checks that red reflectors are on the back-outer edges of the drill and are clearly visible.
• Checks that amber reflectors are on the side and front outer edges of the drill and are clearly visible
• Travel at a reasonable and safe speed. “Never exceed maximum speed of 25 mph”. Reduce speed and /
or use lower gear on rough ground or slopes.
• Transport drill in its narrowest configuration. All attachments folded.
• No sudden stops, stop slowly.
• Properly adjust and use mirrors on transport vehicles as required.
• Signals and check behind when turning.
• Be sure to have clear visibility while turning.
• Be extremely cautious in poor visibility situations such as; hills, poor weather conditions and at night.
2/3 of roadway farm accidents occur while turning
Failure to follow any of these safety warnings could cause
series injury or death. Use good judgement when
transporting and maintain control at all times. Comply with
state and local laws and regulations. Always strive to
prevent accidents and watch out for other vehicles.
To Next Page
Loading...