starting the engine .....................................
(current page)
heating/air conditioning programming .......
(current page)
6.30
ENG_UD69717_4
Programmation démarrage moteur (XNX - Renault)
Engine start-up programming
ENGINE START-UP PROGRAMMING (1/3)
Programming the departure time
Activate the function then set your de-
sired departure time:
– press the UP and DOWN arrows to
scroll through the hours and minutes
until you get the desired time;
To activate start-up by program-
ming, you must select a time at least
fifteen minutes later than the time
displayed by the multimedia system.
Programming engine start
– use the air conditioning controls to
set the desired temperature (de-
pending on the equipment) in the
passenger compartment when re-
starting the engine, then set to de-ic-
ing mode (please see section 2 in the
vehicle user manual);
– turn off the ignition.
When locking your vehicle, two flashes
will appear then the hazard warning
lights and indicator lights switch on for
approximately three seconds to indi-
cate that the programming has been
taken into account.
Note: the marker 1 reminds you of the
vehicle start time that you have already
set.
“Program
engine start”
menu
From the “Settings” menu, select the
“Vehicle” tab.
This function enables you to program
the engine to start, in order to heat or
ventilate the passenger compartment
up to 24 hours before using the vehicle.
Programming engine start
Ready at
Wake up every 2 hours
1
To Next Page
Loading...
