63
Homing
Homing is the procedure by which the machine locates the probe's position in the working volume by moving to
the zero positions of each individual scale (referencing).
Prior to the commencement of the operation all fixture plates should be removed and the probe platform should
be approximately located in the centre of the machine's volume. The machine's movements during homing
depend upon the location of the probe when homing was launched. Homing will take approximately 20 seconds
to complete.
Homing is required at each machine start-up and sometimes after a collision or error. If a part program is
running and homing is required, a warning message will be displayed to warn the user that homing is about to
commence. If the part program was launched from Organiser, you will need to re-start the part program when
the homing sequence has finished.
• Please wait until the homing message appears (Homing is about to commence. Please ensure nothing
obstructs the homing path. If homing is cancelled then limited functionality will be available).
• Click on the “green tick” to continue.
• Click on “Organiser”.
To Next Page
Loading...
