81
Dismantling and Disposal
1. Use the “Configure brakes for transport” app available on the controller (ask Renishaw support for location).
2. Remove any fixture plates from the Equator.
3. Disconnect all power supplies.
4. Unplug the Equator system from the controller.
5. Disconnect the screen, mouse and keyboard from the controller.
6. Unplug the stop button.
7. If returning the system to Renishaw as part of the RBE scheme, repackage the system using the reverse of
the unpacking instructions. If not, dispose of the system according to the WEEE regulations (see the WEEE
information section on page 5).
To Next Page
Loading...
