35
Equator Controller
Where this symbol is displayed on the product, the user must refer to the user guide for
information and safety advice
• There are no user serviceable parts inside the controller.
• The Equator system must be connected to a supply incorporating a protective earth conductor via a three-
core mains cable.
• The equipment is isolated from AC power by disconnection of the IEC mains connector. If any additional
means of isolation is required, it must be specified and fitted by the machine manufacturer or the installer
of the product. The isolator must be sited within easy reach of the operator and comply with BS EN IEC
61010-1:2001 and any applicable national wiring regulations for the country of installation.
• The Equator Controller can be placed either standing or lying on its side, but should be given a reasonable
protection from liquid spillage.
• The fans for cooling the equipment must not be obstructed. Fans are located on the front and back of the
controller. Ensure that the Equator Controller fans are located at least 10 cm from any surface.
To Next Page
Loading...
