3.7
System
installation
Installing the batteries
NOTES:
See page 5.2, “Changing the batteries”, for a list of suitable battery types.
If dead batteries are inadvertently inserted, the LEDs will remain a constant red.
Do not allow coolant or debris to enter the battery compartment. When inserting batteries, check that
the battery polarity is correct.
After the batteries have been inserted, the LEDs will display the current probe settings, for details,
(see page 4.1 “Reviewing the probe settings”, for further information).
CAUTION: Remove the battery isolation device from the battery compartment before use.
¬ Take care not to short the battery contacts as this may be a re hazard. Ensure the contact strips
are located securely.
1
4
2
3
¬