Renishaw OMP40-2 - Maintenance; Cleaning the Probe

5.1
Maintenance
You may undertake the maintenance routines described in these instructions.
Further dismantling and repair of Renishaw equipment is a highly specialised operation, which must
be carried out at an authorised Renishaw Service Centre.
Equipment requiring repair, overhaul or attention under warranty should be returned to your supplier.
Cleaning the probe
Wipe the window of the probe with a clean cloth to remove machining residue. This should be done on
a regular basis to maintain optimum transmission.
Maintenance
CAUTION: The OMP40-2 has a glass window. Handle with care if broken to avoid injury.
see Section 4,“Maintenance”