Renishaw OMP40-2 - Changing the Probe Settings

4.3
Trigger Logic
Key to the symbols
LED short flash
LED long flash
Deflect the stylus for less
than 4 seconds to move
to the next menu option.
Deflect the stylus for
more than 4 seconds to
move to the next menu.
To exit, leave the stylus
untouched for more than
20 seconds.
LED check
Changing the probe settings
Insert the batteries or, if they have already been installed, remove them for five seconds and then refit them.
Following the LED check, immediately deflect the stylus and hold it deflected until eight red flashes
have been observed (if the battery power is low, each red flash will be followed by a blue flash).
Keep the stylus deflected until the “Switch-off method” setting is displayed, then release it.
CAUTION: Do not remove the batteries whilst in conguration mode. To exit, leave the stylus
untouched for more than 20 seconds.
Switch-off method
Optical off Short timeout
12 s
Medium timeout
33 s
Long timeout
134 s

1
> 5 s
2
3
Battery status
Battery good
or
Battery low
Deflect the stylus and hold it deflected until after the battery
status has been displayed at the end of the review sequence.
Return to “Switch-off method”
New settings
complete
Optical power
Low Standard Ultra low
Enhanced trigger filter
Off
0 ms
On
10 ms
Optical transmission method
Legacy
(start filter off)
Legacy
(start filter on)
Modulated
PROBE 1
Modulated
PROBE 2
Modulated
PROBE 3