4.5
Trigger Logic
Battery status
Battery good
or
Battery low
Whilst the status LEDs are flashing yellow to confirm that
a master reset is required, release the stylus and then
hold the stylus deflected again until the eight yellow flash
sequence has ended.
System status LED
LED check
Switch-off method
Probe is now back in the Trigger
Logic menu and will display
“Switch-off method”.
Configure probe settings as required using Trigger Logic
Deflect the stylus for 20 seconds until the
status LEDs start to flash yellow eight times.
2.
3.
Previous settings have been cleared.
The probe now has default settings.
Switch-off method
Optical off
or
Short timeout
12 s
or
Medium timeout
33 s
or
Long timeout
134 s
×
×
To Next Page
Loading...
