OMP40-2 installation guide
ii
Contents
Operating envelopes ......................................................3.3
Positioning the OMM-2C receiver with OSI or OSI-D interface ......................3.4
Preparing the OMP40-2 for use ................................................3.5
Fitting the stylus ..........................................................3.5
Stylus weak link ..........................................................3.6
Installing the batteries .....................................................3.7
Mounting the probe on a shank ..............................................3.8
Stylus on-centre adjustment ................................................. 3.9
Calibrating the OMP40-2 .....................................................3.10
Why calibrate a probe? ...................................................3.10
Calibrating in a bored hole or on a turned diameter .............................. 3.10
Calibrating in a ring gauge or on a datum sphere ...............................3.10
Calibrating the probe length ................................................3.11
Trigger Logic™ ...............................................................4.1
Reviewing the probe settings ..................................................4.1
Probe settings record ........................................................4.2
Changing the probe settings ...................................................4.3
Master reset function ......................................................... 4.4
Operating mode ............................................................. 4.6
Maintenance .................................................................5.1
Maintenance ...............................................................5.1
Cleaning the probe ..........................................................5.1
Changing the batteries .......................................................5.2
OMP40M system .............................................................6.1
OMP40M system ............................................................ 6.1
OMP40M dimensions ........................................................6.1
OMP40M screw torque values .................................................6.2
OMP40-2LS system ..........................................................7.1
Introduction ................................................................7.1
Performance envelope with an OMM-2 receiver with OSI or OSI-D interface or OMI-2 /
OMI-2T / OMI-2H interface / receiver ..........................................7.1
Fault-finding .................................................................8.1
Parts list .....................................................................9.1
To Next Page
Loading...
Need help?
General
