Configuration
80
Doc No: UMAN\FL\0110
Rev. No.: 1.02B
M00021 Clock/calendar illegal Read Only ON when clock/calendar data is illegal
value warning
M00022 Retentive data invalid warning Read Only ON when retentive data in RAM are invalid
M00027 Watchdog timer error Read Only ON at error state
M00029 I/O mismatch error Read Only ON at error state
M00031 I/O communication error Read Only ON at error state
M00033 Ladder Scan time error Read Only ON when the scan time exceeds 200ms (default)
M00480 System timer coil for 0.1 Read Only Toggle at 50 % duty cycle
sec interval
M00481 System timer coil for 0.2 Read Only Toggle at 50 % duty cycle
sec interval
M00482 System timer coil for 0.4 Read Only Toggle at 50 % duty cycle
sec interval
M00483 System timer coil for 0.8 Read Only Toggle at 50 % duty cycle
sec interval
M00484 System timer coil for 1 Read Only Toggle at 50 % duty cycle
sec interval
M00485 System timer coil for 2 Read Only Toggle at 50 % duty cycle
sec interval
M00486 System timer coil for 4 Read Only Toggle at 50 % duty cycle
sec interval
M00487 System timer coil for 8 Read Only Toggle at 50 % duty cycle
sec interval
M00496 Timer interrupt ladder Read Only ON when Timer program is executing
execution status
M00497 IO1 interrupt execution status Read Only ON when IO1 program is executing
M00498 IO2 interrupt execution status Read Only ON when IO2 program is executing
M00512 ALWAYS ON Read Only This coil is always ON
M00513 ALWAYS OFF Read Only This coil is always OFF
To Next Page
Loading...
