Retsch SR 300 - Default Chapter; Table of Contents

3
Table of Contents
1 Notes on the Manual ............................................................................................................................. 6
1.1 Disclaimer .......................................................................................................................................... 6
1.2 Copyright............................................................................................................................................ 6
1.3 Explanations of the Safety Instructions ............................................................................................. 7
1.4 General Safety Instructions ............................................................................................................... 8
1.5 Repairs ............................................................................................................................................... 9
2 Confirmation Form for the Managing Operator ................................................................................ 10
3 Technical Data ..................................................................................................................................... 11
3.1 Protective Equipment ....................................................................................................................... 11
3.2 Degree of Protection ........................................................................................................................ 11
3.3 Emissions......................................................................................................................................... 11
3.4 Electromagnetic Compatibility (EMC) .............................................................................................. 12
3.5 Rated Power .................................................................................................................................... 12
3.6 Motor Rotation Speed ...................................................................................................................... 12
3.7 Dimensions and Weight ................................................................................................................... 12
3.8 Required Floor Space ...................................................................................................................... 13
3.9 Receptacle Volume .......................................................................................................................... 13
3.10 Feed Grain Size ............................................................................................................................... 13
3.11 Suitable Sieve Diameters ................................................................................................................ 13
4 Packaging, Transport and Installation .............................................................................................. 14
4.1 Packaging ........................................................................................................................................ 14
4.2 Transport.......................................................................................................................................... 14
4.3 Temperature Fluctuations and Condensation ................................................................................. 15
4.4 Conditions for the Installation Site ................................................................................................... 15
4.5 Electrical Connection ....................................................................................................................... 16
4.6 Type Plate Description ..................................................................................................................... 17
5 First Commissioning ........................................................................................................................... 18
5.1 Setting up as Table-top Device........................................................................................................ 19
5.2 Setting up on Base Frame ............................................................................................................... 20
6 Operating the Device .......................................................................................................................... 25
6.1 Use of the Device for the Intended Purpose .................................................................................... 25
6.2 Principle of Operation ...................................................................................................................... 26
6.3 Views of the Instrument ................................................................................................................... 27
6.3.1 Front ............................................................................................................................................. 27
6.3.2 Back ............................................................................................................................................. 28
6.4 Switching On / Off ............................................................................................................................ 29
6.5 Opening and Closing of the Device ................................................................................................. 29
6.5.1 Opening ....................................................................................................................................... 30
6.5.2 Closing ......................................................................................................................................... 30
6.6 Emergency Unlocking ...................................................................................................................... 31
6.7 Inserting the Grinding Set ................................................................................................................ 32
6.7.1 Inserting the Grinding Chamber Cartridge ................................................................................... 33
6.7.2 Inserting the Rotor ....................................................................................................................... 33
6.7.3 Inserting the Retaining Frame ..................................................................................................... 34
6.8 Removing the Grinding Set.............................................................................................................. 35
6.9 Mounting the Sample Receptacle .................................................................................................... 35
7 Controlling the Device ........................................................................................................................ 37
7.1 Operating Controls, Display and Functions ..................................................................................... 37
7.2 Manual Mode ................................................................................................................................... 37
7.2.1 Setting the Rotation Speed .......................................................................................................... 37
7.2.2 Start Process ............................................................................................................................... 37
7.2.3 Feeding Sample Material ............................................................................................................. 38