To unlock the locking mechanism (K) the hexagon socket wrench (NE2) must be pressed
further into the opening with a little force.
While pressing, turn the hexagon socket wrench (NE2) clockwise up to the stop.
The upper, electrical locking mechanism of the door is now unlocked and the door can be
opened, if previously the lower, mechanical locking mechanism has been unlocked.
6.7 Inserting the Grinding Set
Cutting injuries
Sharp cutting edges
The sharp cutting edges on the rotors and/or the cutting bars in the
grinding chamber can lead to hand lacerations.
Grasp the rotor only on the hub and do not touch the cutting edges
or bars.
Wear cut-resistant safety gloves.
Wear or damage of the device
Operation without grinding set
During operation of the device without grinding set, excessive wear or
damage to the device may occur.
Operate the device only with a grinding set mounted.
Fig. 18: Insertion of the grinding set consisting of grinding chamber cartridge, retaining frame and
rotor
To Next Page
Loading...
