Retsch SR 300 - Page 36

Operating the Device
36
Fig. 24: Clamping the filter hose
 Use the two horizontally unfolded clamping levers (N) to lift up the collecting receptacle (M).
 Position the collecting receptacle (M) flush over the groove of the filter hose (L).
 Turn the collecting receptacle (M) clockwise until the clamping lever is situated over the
clamping edge.
 Press the clamping levers (N) downwards with the open palm to clamp the collecting
receptacle (M).
Fig. 25: Clamping the collecting receptacle
CAUTION
C13.0032
Danger of crushing
Clamping the clamping levers
 If the clamping levers are completely enclosed by the hand, the fingers
can be pinched.
 Do not clasp the clamping levers completely with the fingers during
clamping.
 Press down the clamping levers only with the palm.
M
N
AF1
AF2
N
M
L