Nr. Code Name Description
45 E.Par Parameter settings invalid
Parameter settings are invalid after firmware update or
extension card removed
46 U.Par
Unknown parameter restore
error
An unknown parameter is skipped during parameter re-
store
48 idA- Internal communication error
Internal error caused by communication between con-
trol boards
49 idP- Internal parameter error Internal error caused by parameter handling
50 idE- Converter internal error Converter has internal error, contact with service
51 OCd- Extension card internal error
Extension card was successfully detected by the device
at startup, but the communication failed afterwards
52 OCc
Extension card PDOs configura-
tion error
Process data configuration error for field bus communi-
cation
54 PcE-
Remote control communication
error
Error if communication to IndraWorks/ConverterWorks
is lost during remote control
55 PbrE Parameter backup / restore error
Error occurs during parameter backup and restore oper-
ation
56 PrEF
Parameter restore error after
firmware update
Error occurs if parameter settings cannot be restored
after firmware update
60 ASF- Application firmware error
Error message if the application firmware was not loa-
ded correctly or trail use is over
61 APE1 Application error 1
Error which can be thrown by the application, descrip-
tion in application manual
62 APE2 Application error 2
63 APE3 Application error 3
64 APE4 Application error 4
65 APE5 Application error 5
Bosch Rexroth AG
Diagnosis
EFC 3610 / EFC 5610
86/87
DOK-RCON03-EFC-X610***-QU11-EN-P
To Next Page
Loading...
Need help?
General
