NetWare 3.x, 4.x, 5/5.1- Advanced Settings
69
5
M
MM
M
Assign print queues to the created printer as follows:
NetWare 3.x
A From the [Print Server Configuration] menu, select [Queues Serviced By Printer].
B Select the printer created in step
L
LL
L
.
C Press the {
{{
{INSERT}
}}
} key to select a queue serviced by the printer.
Note
❒ You can select more than one queue at a time.
D Follow the instructions on the screen to make other necessary settings.
When you have finished the above steps, make sure that the queues are as-
signed.
E Press the {
{{
{ESC}
}}
} key until “Exit?” appears, and then select [Yes] to exit
PCONSOLE.
Note
❒ To make sure that the printer is correctly configured, type the following
from the command prompt.
F:> USERLIST
❒ If the printer works as configured, the name of the print server appears
as an attached user.
❒ NetWare 3.x ends here.
NetWare 4.1
A Click [Assignments], and then click [Add] in the [Assignments] group.
B In the [Available objects] box, click the queue created in step
K
KK
K
, and then
click [OK].
C Click [Configuration], and in the [Printer type] box, select [Parallel] using the
drop-down menu, and then click [Communication].
D Click [Manual load] in the [Communication type] group, and then click [OK].
E After checking the settings, click [OK].
N
NN
N
Create a print server as follows:
A Select the context specified using the NIB Setup Tool (step
I
II
I
-A
AA
A), and on
the [Object] menu, click [Create].
B In the [Class of new object] box, click “Print Server”, and then click [OK].
When you are using NetWare 5/5.1, click “Print Server (Non NDPS)”.
C In the [Print Server name] box, type the name of the print server.
Important
❒ Use the same name as that specified using the NIB Setup Tool. (Step
H
)
D Select the [Define additional properties] check box, and then click [Create].
To Next Page
Loading...
