Key Operator Setting
74
7
Note
If there is an End Receiver already
programmed, a receiver name is
shown. If you want to change the
receiver, press the
{
Clear/Stop
}
key and proceed to step
F
.
To cancel Forwarding, press the
{Cancel} key and proceed to
step
G
.
F Specify an End Receiver using the
Quick Dial key or searching by
the destination list, and then
press the {OK} key.
See p.34 “Searching for a Destina-
tion”, Facsimile Reference <Basic
Features>.
G Press the {User Tools/Counter} key.
The standby display appears.
Quitting the forwarding function
A Press the {User Tools/Counter} key.
B Select [Fax Features] using {U} or
{T}, and then press the {OK} key.
C Select [Key Operator Tools] using
{U} or {T}, and then press the
{OK} key.
D Select [Forwarding] using {U} or
{T}, and then press the {OK} key.
E Select [Off], using {U} or {T}, and
then press the {OK} key.
F Press the {User Tools/Counter} key.
The standby display appears.
Forwarding Mark
You can print a Forwarding Mark on
the receiver's messages that have
been forwarded.
The receiver can distinguish between
forwarded messages and usual recep-
tions.
Note
You can specify whether or not to
print a Forwarding Mark in the
User Parameters. See p.76 “User
Parameters” (switch 02, bit 0).
ABZ
S.eps
FAX
.t
FAX
.t
FAX
.t
FAX
.t
G
mten
e.eps
To Next Page
Loading...
