Using Key Operator Settings
79
7
Changing the User Parameters
Important
We recommend you print and
keep a User Parameter list when
you program or change a User Pa-
rameter. See p.80 “Printing the
User Parameter List”.
Do not change any bit switches
other than those shown on the pre-
vious pages.
A Press the {User Tools/Counter} key.
B Select [Fax Features] using {U} or
{T}, and then press the {OK} key.
C Select [Key Operator Tools] using
{U} or {T}, and then press the
{OK} key.
D Select [Parameter Setting] using {U}
or {T}, and then press the {OK}
key.
E Select [Parameter Setting] using {U}
or {T}, and then press the {OK}
key.
F Select the switch number you
want to change using {U} or {T},
and then press the {OK} key.
G Select the bit number you want to
change.
When the bit number is pressed,
the current value switches be-
tween 1 and 0.
Note
Repeat from step
G
to change
another bit number for the same
switch.
H Press the {OK} key.
Note
To cancel these settings, press
the {Cancel} key. The display re-
turns to that of step
F
.
I Repeat steps
F
and
H
to change
the switch settings.
J After all the settings are finished,
press the {User Tools/Counter} key.
The standby display appears.
ABZ
S.eps
FAX
.t
FAX
.t
FAX
.t
FAX
.t
FAX
.t
FAX
.t
To Next Page
Loading...
