Select the protocol of the machine whose configuration you want to change.
If you are using IPv4 SNMPv3, enter the user authentication.
3. In the list, select a machine whose configuration you want to change.
4. On the [Tools] menu, click [NIB Setup Tool].
A Web browser opens and the dialog box for entering the login user name and password for the
Web Image Monitor administrator appears.
NIB Setup Tool starts when the network interface board is default. Follow the instructions on the screen.
5. Enter the login user name and password, and then click [Login].
For details about the user name and password, consult your network administrator.
6. Click [Configuration].
7. Click [Program/Change Administrator] on the [Device Settings] area, and then change the
settings.
8. Click [OK].
9. Click [Logout].
10. Quit Web Image Monitor.
11. Quit SmartDeviceMonitor for Admin.
• For details about login user names and passwords, see Security Reference, which is the administrator's
manual.
Checking the Machine Status
Follow the procedure below to check machine status.
1. Start SmartDeviceMonitor for Admin.
2. On the [Group] menu, point to [Search Device], and then click [IPv4], [IPX/SPX] or [IPv4
SNMPv3].
A list of machines using the selected protocol appears.
Select the protocol of the machine whose configuration you want to change.
If you are using TCP/IP SNMP v3, enter the user authentication.
4. Monitoring and Configuring the Printer
142
To Next Page
Loading...
Need help?
General
