Changing the protocol
This section describes how to change the protocol.
1. Select [SMB] or [FTP] using [ ] or [ ], and then press the [OK] key.
A confirmation message appears.
2. Press [Yes].
Changing the protocol will clear all settings made under the previous protocol.
3. Enter each item again.
Deleting an NCP Folder
This section describes how to delete the registered NCP folder.
1. Press the [User Tools/Counter] key
2. Select [System Settings] using [ ] or [ ], and then press the [OK] key.
3. Select [Administrator Tools] using [ ] or [ ], and then press the [OK] key.
5. Registering Addresses and Users for Facsimile/Scanner Functions
316
To Next Page
Loading...
