Checking host name when deleting the job
msh> lpr chkhost {on|off}
• The default is “on”.
If “on” is selected, you can delete print jobs only from the IP address of the host that sent the print job.
If LPR is disabled, you can also delete print jobs sent from IP addresses other than that of the host.
Printer Error Detection Function
lpr prnerrchk {on|off}
• The default is “off”.
If you set this to “on”, the printer stops receiving data and will wait until the error is resolved before
continuing processing a job.
netware
Use the “netware” command to view and configure the NetWare settings such as the print server name or
file server name.
NetWare Printer Server Names
msh> netware pnamecharacter string
• Enter the NetWare print server name using up to 47 characters.
NetWare File Server Names
msh> netware fname character string
• Enter the NetWare file server name using up to 47 characters.
Encap type
msh> netware encap {802.3|802.2|snap|ethernet2|auto}
Remote Printer Number
msh> netware rnum [0-254]
• The default is 0.
Timeout
msh> netware timeout [3-255]
• The default is 15.
Printer server mode
msh> netware mode pserver
msh> netware mode ps
Remote printer mode
msh> netware mode rprinter
Remote Maintenance by telnet
173
To Next Page
Loading...
Need help?
General
