Registering a Protection Code
This section describes how to register a Protection Code.
You can stop sender's names or folders being accessed by setting a protection code.
You can use this function to protect the following:
• Folders
You can prevent unauthorized access to folders.
• Sender's names
You can prevent misuse of sender's names.
Registering a Protection Code to a Single User
This section describes how to register a Protection code to a single user.
1. Press the [User Tools/Counter] key.
2. Select [System Settings] using [ ] or [ ], and then press the [OK] key.
3. Select [Administrator Tools] using [ ] or [ ], and then press the [OK] key.
4. Select [Address Book Management] using [ ] or [ ], and then press the [OK] key.
5. Registering Addresses and Users for Facsimile/Scanner Functions
334
To Next Page
Loading...
