devicename
Use the “devicename” command to display and change the printer name.
View settings
msh> devicename
Printer name configuration
msh> devicename name “string”
• Enter a printer name using up to 31 alphanumeric characters.
• Set single names for each printer.
Printer name initialization
msh> devicename clear name
• Reset the printer name to its default.
dhcp
Use the “dhcp” command to configure DHCP settings.
View settings
The following command displays the current DHCP settings.
msh> dhcp
Configuration
You can configure DHCP.
msh> dhcp “interface_name” {on|off}
• Click {on} to enable dhcp. Click {off} to disable DHCP.
• If the DNS server address and domain name are obtained from DHCP, be sure to click {on}.
• wlan can be specified only when the IEEE 802.11 interface is installed.
Interface name Interface configured
ether Ethernet interface
wlan IEEE 802.11 interface
Current interface priority configuration display
msh> dhcp priority
Interface priority configuration
msh> dhcp priority “interface_name”
Remote Maintenance by telnet
163
To Next Page
Loading...
