Message Problem and solutions
add_sess_IPv6: community <community name>
already defined.
The same community name already exists. Use
another community name.
add_sess_IPX: bad trap addr: <IPX address>
community <community name>
The IPX address (00:00:00:00:00:00) is
unavailable when the community access type is
TRAP. Specify the host IPX address for the TRAP
destination.
add_sess_IPX: community <community name>
already defined.
The same community name already exists. Use
another community name.
adjust time server <NTP server name> offset: xx sec. ncsd tells you the timing of the NTP server and
whether or not the time system clock is set.
Attach FileServer=<file server> Connection to the file server as the nearest server
has been established.
Attach to print queue <print queue name> (In the print server mode) Attached to the print
queue.
centrod is disabled. Communication via parallel connections
unavailable because centrod is disabled in the
security mode.
Enable centrod in the security mode.
child process exec error! <process name> The network service failed to start. Turn the printer
off and then on. If this does not work, contact your
service or sales representative.
Connected DHCPv6 server <IPv6 address> The IP address was successfully received from the
DHCPv6 server.
connection from <IP address> A user logged in from the host <IP address>.
Could not attach to FileServer <error number> (In the remote printer mode) Connection to the file
server has not been established. The file server has
refused the connection. Check the file server
configuration.
Could not attach to PServer <print server> (In the remote printer mode) Connection to the print
server has not been established. The print server
has refused the connection. Check the print server
configuration.
Message List
217
To Next Page
Loading...
