• You can enter a path using up to 128 characters.
• When [Do not Specify] is selected in step 11, the SMB User Name and SMB Password that you have
specified in Default User Name/Password (Send) of File Transfer settings applies.
• If the connection test fails, check the settings, and then try again.
• If User Authentication is specified, contact your administrator.
• p.36 "File Transfer"
• p.230 "Registering Names"
Locating the SMB folder manually
This section describes how to locate the SMB folder manually.
1. Select [Manual Entry] using [ ] or [ ], and then press the [OK] key.
2. Enter the path and then press the [OK] key.
If the format of the entered path is not correct, a message appears. Press [Exit], and then enter the
path again.
• Enter the path using this format: "\\ServerName\Share- Name\PathName".
• You can also enter an IPv4 address.
• You can enter a path using up to 128 characters.
Locating the SMB folder using browse network
This section describes how to locate the SMB folder using Browse Network.
Registering Folders
287
To Next Page
Loading...
