Changing the color balance
Changes the settings stored in color balance programs.
1. Press [Edit / Color].
2. Press [Color], and then press [Adjust Color].
3. Press [Color Balance], and then press [Program Color Balance].
4. Select the program number (1 3) to be changed.
The programmed color balance appears.
5. Change the registered settings.
6. Press [Program Color Balance].
7. Press [Program], and then press the program number to be overwritten.
8. Press [Yes].
The program is overwritten.
9. Press [OK] twice.
Recalling the color balance
Applies settings registered in color balance programs to the copy job.
1. Press [Edit / Color].
2. Press [Color], and then press [Adjust Color].
3. Press [Color Balance], and then press [Program Color Balance].
4. Select the program number you want to use.
5. Press [OK] twice.
• The adjusted settings will be deleted and the initial values will be reset, when Auto Clear has been
performed, when the [Clear Modes] key has been pressed, or when the power has been turned off.
3. Color Copying
98
To Next Page
Loading...
Need help?
General
