Placing Originals
This section describes the procedure for placing originals on the exposure glass and in the ADF.
Take care to place originals after any correction fluid and ink has completely dried. Not taking this
precaution could cause marks on the exposure glass that will be copied onto paper.
• For original sizes you can place on the exposure glass and in the ADF, see “Originals”.
• p.21 "Originals"
Original Orientation
You can specify the original orientation if necessary.
Specify a readable or unreadable orientation according to the orientation of the originals. If you do not
specify the orientation of the originals correctly, some functions might not make copies how you want them.
The default setting is unreadable orientation.
When using the exposure glass, place the original face down. When using the ADF, place it face up.
• Unreadable orientation
When originals cannot be placed in the readable orientation (e.g. A4 or 8
1
/
2
× 11 ), place them
in unreadable orientation. You can make copies how you want.
1. ADF
2. Exposure glass
• Readable orientation
Select this mode when the original orientation is the same as the copy paper orientation.
Placing Originals
25
To Next Page
Loading...
Need help?
General
