Input / Output
This section describes the user tools in the Input / Output menu under Copier / Document Server Features.
Switch to Batch
You can select to have Batch mode or SADF mode displayed when you press [Original Settng].
Default: [Batch]
SADF Auto Reset
In SADF mode, an original must be set within a specified time after the previous original has been fed.
Default: [5 seconds]
You can adjust this time from 3 to 99 seconds in increments of 1 second.
Memory Full Auto Scan Restart
When memory becomes full while scanning originals, the machine can make copies of scanned
originals first, and then automatically proceed scanning remaining originals.
Default: [Off]
• On
You can leave the machine unattended to make copies, but sorted pages will not be sequential.
• Off
When memory becomes full, the machine stops operation allowing you to remove the copy
pages delivered on the output tray.
Letterhead Setting
If you select [Yes] in this function, the machine rotates the image correctly.
Default: [No]
Orientation-fixed (top to bottom) or two-sided paper might not be printed correctly depending on
how the originals and paper are placed.
Staple Position
Specify which staple type has priority to be shown on the initial display.
Default for “Staple Position 1”: [Staple: Top 1]
Default for “Staple Position 2”: [Off]
Default for “Staple Position 3”: [Off]
Default for “Staple Position 4”: [Off]
Simplified Screen: Finishing Types
You can select which key is displayed with higher priority for “Finishing Types” on the Simplified
Screen.
Default for “Simplified Screen: Finishing Types 1“: [Do not Display]
Input / Output
211
To Next Page
Loading...
Need help?
General
