• When placing an original in the ADF, insert the left edge of the original in the ADF.
• To copy onto custom size envelopes, you must specify the envelope's dimensions. Measure the vertical
dimension of the envelope with the flap closed.
1. Vertical size
2. Horizontal size
• Check the envelopes are not damp.
• Do not load envelopes above the limit mark. For the number of envelopes that you can set on the
bypass tray, see “Recommended Paper Sizes and Types”, About This Machine.
• Check there is no air in the envelopes before loading.
• To get better print quality, it is recommended that you set the right, left, top, and bottom print margin,
to at least 15 mm (0.6 inch) each.
• You cannot print envelopes with the Duplex function.
• Load only one size and type of envelope at a time.
• Before loading envelopes, flatten leading edges (the side going into the machine) by pressing a pencil
or ruler across them.
• Before loading envelopes, check they are rectangular in shape.
• For details about supported envelope types, see “Envelopes”, About This Machine.
• You can also copy onto envelopes from the paper trays. For details about how to set envelopes and
what sizes of envelope you can use, see “Changing the Paper Size in Trays 1 - 4”, About This Machine.
2. Basic Copying
50
To Next Page
Loading...
Need help?
General
