29
3. Other Print Operations
Form Feed
Use the form feed function to continue printing when a paper size or paper type
error occurred.
This function can be performed using the control panel.
Important
❒ The tray cannot be changed if the following function is set:
• Duplex Print to a tray that does not support duplex printing
•Cover Sheet
❒ If the paper that is loaded is larger than the paper size specified in the printer
driver, using the form feed function could result in a paper jam. Use form feed
only if the paper is the same as or smaller than the paper size specified in the
printer driver.
Performing Form Feed
Use the following procedure to perform form feed.
A While an error message is displayed on the control panel, press the
{Stop/Start} key.
B Press {U} or {T} to select the tray, and then press the {#Enter} key.
Printing begins on paper from the selected tray.
Note
❒ If you want to print after adding paper to the tray, load the correct paper,
and then press the {Stop/Start} key.
❒ If a tray with a smaller paper size is selected, the print job may be cut short,
or other problems may occur.
To Next Page
Loading...
