6
Handling the Machine's Interior
R WARNING:
R CAUTION:
• Do not attempt any maintenance or troubleshooting other than that
mentioned in this manual. This machine contains a laser beam gener-
ator and direct exposure to laser beams can cause permanent eye
damage.
• Do not put your hands inside the printer when the input tray is re-
moved. Some internal parts become hot and are a burn hazard.
• The inside of this printer becomes very hot. Do not touch parts labelled “v”
(indicating a hot surface).
• The fusing section of this machine might be very hot. Caution should be tak-
en when removing misfed paper.
• Lifting the paper feed unit carelessly or dropping it may cause injury.
• Do not pull out the paper tray forcefully. If you do, the tray might fall and
cause an injury.
• Before installing the memory unit, turn off the printer's power switch and un-
plug the power cable. After installing the memory unit, be sure to close the
memory unit cover, and then turn the machine back on. Do not turn on the
machine before closing the memory unit cover.
• Take care to avoid cutting your hands when loading paper.
To Next Page
Loading...
Need help?
General