Replacing the Fusing Unit and Transfer Roller
Replace the fusing unit if any of the following messages appear on the display:
Replace the transfer roller at the same time.
Replacing the Fusing Unit
• The fusing unit becomes very hot. When installing a new fusing unit, turn off the printer and wait at
least an hour before replacing the old fusing unit. Not allowing the unit to cool may result in burns.
1. Turn off the printer and unplug the power cable.
2. Push up the lever on the right side, and open the printer's right cover carefully.
Replacing the Fusing Unit and Transfer Roller
137
To Next Page
Loading...
