Thin paper
Paper thickness 52 to 59 g/m
2
(14 to 16 lb.)
Printer setup
Select [Paper Input] [Paper Type: XXX] (XXX:
Tray 1 to 5, Bypass Tray) [Thin Paper].
Printer driver setup Select [Thin Paper] in [Paper Type].
Supported paper feeding tray
Any input tray can be used.
• Make sure paper is not stacked higher than
the upper limit mark ( ) inside the tray. When
using the bypass tray, make sure paper is not
stacked higher than the paper guides inside
it.
Duplex printing Not supported
OHP transparencies
Printer setup
Select [Paper Input] [Paper Type: Bypass Tray]
[OHP transparencies].
Printer driver setup Select [OHP transparencies] in [Paper Type].
Supported paper feeding tray Bypass tray
Paper capacity 50
Duplex printing Not supported
Additional cautions
• When loading OHP transparencies, take care
not to load them upside down. Doing so may
cause a malfunction.
• Make sure to fan OHP transparencies every
time before printing. Leaving OHP trans-
parencies loaded in the paper tray may cause
them to stick together and result in a paper
misfeed.
• If multiple OHP transparencies are fed at the
same time, load them one by one.
Paper Recommendations
89
To Next Page
Loading...
