IEEE 802.11b (Wireless LAN) Configuration
Configure the printer to use IEEE 802.11b (Wireless LAN). The following table shows the control panel
settings and their defaults. These items appear in the [Host Interface] menu.
Setting Name Default
Communication Mode 802.11 Ad hoc
Channel
13
11
Communication Speed Auto
SSID blank
WEP Off
• Ethernet and wireless LAN (IEEE 802.11b) cannot be used at the same time.
• To use IEEE 802.11b (Wireless LAN), set the following using the control panel: press the [Menu] key,
and then select [Host Interface], [Network], [LAN Type], and then [IEEE 802.11b]. In addition, set
the IP address, subnet mask, gateway address, DHCP, Frame Type (NW), and active protocol as
explained in p.67 "Ethernet Configuration".
1. Press the [Menu] key.
4. Configuration
76
To Next Page
Loading...
