Loading Paper
This section describes how to load paper into the paper tray or onto the bypass tray.
Loading Paper into the Paper Tray, 500/1000-sheet Paper Feed Unit
The following example explains how to load paper into paper trays, and how to change paper size.
The same procedure can be used for all trays. Tray 2 is used as an example.
• Make sure paper is not stacked higher than the upper limit mark inside the paper tray. Paper misfeeds
might occur.
• Do not mix different types of paper in the same paper tray.
• During printing, do not open or close the printer covers or bypass tray, or pull out or push in the paper
tray.
• The default of tray 1 is as follows:
• : A4
• : 8
1
/
2
× 11 (Letter)
1. Carefully pull out the paper tray until it stops.
When printing using the bypass tray, do not pull out the paper tray.
Loading Paper
97
To Next Page
Loading...
