9. Set [Communication Speed] in the same way.
The default is [Auto Select]. If you need to change the transmission speed depending on the environ-
ment you are using, select the appropriate transmission speed.
10. Print a configuration page to confirm the settings.
• For details about printing the configuration page, see “Test Printing”, Quick Installation Guide.
Setting the SSID
When "Communication Mode" is set to "Infrastructure" or "802.11 Ad hoc", you must specify the Service
Set Identifier (SSID) of the wireless access point that the printer will connect to for network access.
Ask the network administrator for the SSID to use.
1. In the [IEEE 802.11b] menu, press the [ ] or [ ] key to select [SSID Setting], and then press
the [OK] key.
If an SSID has been set, you can check the current SSID setting.
2. Press the [ ] or [ ] key to select [Enter SSID], and then press the [OK] key.
3. Press the [ ] or [ ] key to enter characters, and then press the [OK] key.
You can switch among upper/lower cases, numeric codes, and symbols by pressing [ABC/123].
The characters that can be used are ASCII 0 20–0 7e (32 bytes).
4. Print a configuration page to confirm the settings.
• The SSID can also be set using a Web browser. For details, see the Web Image Monitor Help, and
“Configuring the Network Interface Board Using Web Browser”, Software Guide.
• For details about printing the configuration page, see ”Test Printing”, Quick Installation Guide.
4. Configuration
78
To Next Page
Loading...
Need help?
General