7. Lower the upper unit carefully.
8. Pull the ribbon out of the staple case that you attached.
The ribbon rolls around the staple case. Make sure to pull it out completely.
9. Holding the lever on the cartridge, push the cartridge down gently into the staple unit until
it clicks.
10. Return the staple unit to its original position.
11. Close the front cover of the finisher.
• If you cannot pull out the upper unit, there are staples remaining inside the cartridge. Use all the staples
before replacing the cartridge.
Adding Staples
149
To Next Page
Loading...
Need help?
General