1. Be sure to check the following points:
• The power switch is turned off.
• The power cable is unplugged from the wall outlet.
• The interface cable is unplugged from the printer.
2. If any external options are attached, remove them.
See the relevant sections in this manual and reverse the steps to remove options.
Pull out the handle from the right side of the printer.
3. Pull out the handle from the right side of the printer.
4. Lift the printer with four people by using the handles on both sides of the printer, and then
move it to the place where you want to install it, keeping it horizontal.
5. If you removed options, reattach them.
For details, see the relevant sections in this manual.
• At least four people are required to lift the printer.
• Be sure to keep the printer horizontal while moving it. To prevent toner from being released,
move the printer slowly.
• If optional paper feed units are attached, remove them from the printer and move them sepa-
rately.
11. Appendix
224
To Next Page
Loading...
Need help?
General