10. Fasten the controller board to the printer using the five screws.
• Confirm that the user account enhance unit was correctly installed by printing the configuration page.
If it is correctly installed, "Accounting Module" will appear for "Device Connection" on the configu-
ration page.
• If the user account enhance unit is not installed properly, repeat the procedure from step 2. If it cannot
be installed correctly even after reattempting installation, contact your sales or service representative.
• Please help recycle by returning unneeded user account enhance units to your sales or service rep-
resentative.
• For information about printing the configuration page, see "Test Printing", Quick Installation Guide.
• Install the controller board carefully. See p.26 "Cautions When Re-installing the Controller Board"
for details.
• "Test Printing", Quick Installation Guide
• p.26 "Cautions When Re-installing the Controller Board".
2. Installing Options
42
To Next Page
Loading...
