Ricoh Aficio SP C830DN User Manual

Problem Cause Solution
Misfeeds occur frequently. Paper size setting is not
correct.
• Remove misfed paper. For details
about removing jammed paper,
see p.122 "Removing Jammed
Paper".
• If you load a paper size that is not
selected automatically, you must
specify the paper size with the
control panel. For details about
specifying paper size with the
control panel, see "Changing to a
Size That Is Not Automatically
Detected", Operating Instructions.
Misfeeds occur frequently. There is a foreign object on
the finisher tray.
• Remove misfed paper. For details
about removing jammed paper,
see p.122 "Removing Jammed
Paper".
• Do not place anything on the
finisher tray.
Cannot print in duplex
mode.
You have selected a paper
tray that does not support
duplex printing.
Change the setting for "Apply 2 sided"
in [System Settings] to enable duplex
printing for the paper tray. For details
about setting "Apply 2 sided", see
"Tray Paper Settings", Operating
Instructions.
Cannot print in duplex
mode.
You have selected a paper
type that cannot be used for
duplex printing.
In [Tray Paper Settings], select a paper
type that can be used for duplex
printing. For details about the paper
types that can be used, see "Tray
Paper Settings", Operating Instructions.
"Output tray is full. Remove
paper." appears.
The output tray is full. Remove paper from the output tray to
resume printing. If paper is to be output
to the finisher shift tray, press the
[Suspend] key to suspend printing and
prevent paper from falling off the tray,
and then remove the paper. Press
[Continue] on the display panel to
resume printing.
3. Troubleshooting
82

Ricoh Aficio SP C830DN Specifications