Ricoh Aficio SP C830DN User Manual

When You Cannot Print
Problem Cause Solution
Printing does not start. The power is off. For details about how to turn on the
main power switch, see p.27 "Turning
On/Off the Power".
Printing does not start. The cause is displayed on
the screen of the control
panel.
Check the error message or warning
status on the display panel, and then
take the required action. For details
about solutions, see p.91 "When
Messages Are Displayed".
Printing does not start. The interface cable is not
connected correctly.
For details about how to connect
interface cables correctly, see
"Connecting the Printer", Operating
Instructions.
Printing does not start. The correct interface cable is
not being used.
The type of interface cable to use
depends on the computer. Be sure to
use the correct one. If the cable is
damaged or worn, replace it. For
details about interface cable, see
"Connecting the Printer", Operating
Instructions.
Printing does not start. The interface cable was
connected after the printer
was switched on.
Connect the interface cable before
turning on the main power switch.
Printing does not start. If the printer is using wireless
LAN, failure to print might
result from a weak wireless
signal.
Check the radio signal status of the
wireless LAN in [System Settings]. If the
signal quality is not satisfactory, move
the printer to a location where radio
waves can pass or remove objects that
might cause interference.
You can check the signal status only
when wireless LAN is used in
infrastructure mode. For details about
the radio signal status of the wireless
LAN, see "Interface Settings",
Operating Instructions.
3. Troubleshooting
106

Ricoh Aficio SP C830DN Specifications